A wall can look straight until you put a cabinet against it. A scribe strip helps close the gap while leaving room for drawers and doors to work.
A cabinet comes out of the shop with straight sides. The wall it’s going against might have a little belly, or it might lean just enough to leave daylight at the top. You usually see it as soon as you hold a straightedge against the wall.
A scribe strip is a piece of trim or filler that gets fitted to that wall. One edge stays straight where it meets the cabinet. The other gets shaped to follow the wall. With the cabinet sitting level and plumb, the strip closes the changing gap and gives you a clean line along the side.
The first thing I want to know is how much the wall moves from one point to the next. Check it at the front edge of the cabinet, where the filler will actually sit. Leave enough material to fit the widest part of the gap and still get the finished width you want at the narrowest point. Also think through what’s beside the cabinet. A pull can hit a wall or door casing, and a drawer needs enough clearance to open past anything that sticks out. Those details can determine the filler width before you even pick up a pencil.
For a shop mock-up, hold a scrap strip against a slightly uneven surface and use a compass or scribing tool to transfer the shape. Keep the strip in the same orientation it will have when installed. Cut close to the line and refine the fit a little at a time. Mark the top and the finished face before you take it back to the bench. It’s easy to flip a strip once you’ve got it in your hands.
If you’re planning a wall-to-wall built-in, measure the opening near the floor, in the middle, and near the top. Those three numbers help you plan room for the cabinet and its fillers.

